OO-S-2822
3.6.2.3 Engine accessories. The diesel engine shall be equipped with
batteries, exhaust muffler, air cleaner, oil filter, engine hour meter, and fuel
tank, The capacity of the fuel tank shall be sufficient to run the engine for
not less than 4 hours under full rated load. All other engine accessories
supplied in commercial practice shall be provided.
3.6.2.3.1 Battery(s). Unless otherwise specified (see 6.2.1), the
battery(s) furnished shall be dry charged and shall be in accordance with
W-B-131, without electrolyte. The battery(s) shall be provided with sealed caps
to prevent the intrusion of atmospheric moisture.
As a minimum the panel shall include the
3.6.2.3.2 Engine instrument panel.
following:
a.
Engine hour meter (capacity of 9999 hours).
b.
Keyed ignition/starting switch.
Volt meter or charging indicator.
c.
d.
Fuel gauge.
Oil pressure gauge.
e.
Engine coolant temperature gauge.
f.
3.6.3 Type II saw. All operational components and associated electrical
controls shall operate smoothly without overheating, or other detrimental
effects.
3.6.4 Saw. The saw shall be a radial overarm, woodworking saw, retractable
head, 16-inch (406.4 mm), 1-inch arbor (25.4 mm), and a depth cut of not less
than 4 3/4 inches (44.5 mm). The saw shall be driven by not less than a
5-horsepower 220V, 60 Hz, 3-phase, continuous duty, totally enclosed, fan cooled
motor. The saw shall be mounted so that the saw can be operated from the rear
of the chassis. No part of the machine shall extend beyond the bumper when the
saw is locked in the travel position. Levers, handwheels, cranks, and locks
shall be located to the maximum practicable extent near the front of the saw
within the safe access of the operator. The saw shall be equipped with an
elevating screw or handwheel and means for preventing movement of the cutting
head relative to the elevating mast. Unless otherwise specified (see 6.2.1),
the overall dimensions of the saw shall not be greater than 52 inches (1320.8
mm) in length by 36 inches (914.4 mm) in width and the weight shall be not
greater than 750 lb (340.2 kg). Relative to the chassis, the table length shall
be measured from side to side and the width shall be measured from the extreme
rear toward the front. A weather resistant caution sign shall be placed on the
front of the saw table. The sign shall read: CAUTION - EYE AND EAR PROTECTION
REQUIRED WHILE OPERATING. The word caution shall be the heading and shall be in
letters not less than 3/4-inch (19.1 mm) in height. The balance of the sign
shall be in letters not less than 1/2-inch (12.7 mm) in height. The color of
the lettering shall be black on a yellow background.
3.6.4.1 Cover. The saw shall be furnished with a canvas cover complete with
sash cords and nonferrous eyelets for securing the cover on the unit. The cover
shall enclose the complete saw unit, including the work table, and shall be
fabricated of not less than No. 6, hard texture, cotton duck. The cotton duck
shall be treated to resist fire, water, weather, and mildew. All sharp metal
corners or edges shall be protected -or eliminated to prevent damage to the
cover, caused by wind turbulence while in transit.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business