OO-S-2822
3.8 Servicing and adjusting. Prior to acceptance of the mobile saw assembly
by the Government, the contractor shall service and adjust the mobile saw
assembly for immediate operational use as required in the operator's manual,
The servicing and adjusting shall include at least the following:
a.
Inflation of all tires.
b.
Proper functioning of all electrical systems.
c.
Wheel balancing.
d.
Adjustment of engine to include tune up (type I).
e.
Complete lubrication with grades of lubricants in compliance with
requirements of paragraph 3.7.
Cooling system filled to capacity with clean solution 50/50 water
f.
and antifreeze.
3.8.1 Instruction plates. The equipment shall be equipped with instruction
plates or decals suitably located, describing any special or important
procedures to be followed in operating and servicing the equipment. Plates
shall be securely affixed to the equipment with nonferrous screws or bolts.
3.9 Cleaning, treatment and painting. Surfaces normally painted in good
commercial practice shall be cleaned, treated, and painted as specified herein.
The color of the finish coat shall be as specified (see 6.2.1). Surfaces to be
painted shall be cleaned and dried to insure that they are free from
contaminants such as oil, grease, welding slag and spatter, loose mill scale,
water, dirt, corrosion product, or any other contaminating substances. As soon
as practicable after cleaning, and before any corrosion product or other
contamination can result, the surfaces shall be prepared or treated to insure
the adhesion of the coating system. The painting shall consist of at least one
coat of primer and one finish coat. The primer shall be applied to a clean, dry
surface as soon as practicable after cleaning and treating. Painting shall be
with manufacturer's current materials according to manufacturer's current
processes and the total dry film thickness shall be not less than 2.5 mils over
the entire surface. The paint shall be free from runs, sags, orange peel, or
other defects.
3.10 Workmanship.
3.10.1 Steel fabrication. The steel used in fabrication shall be free from
kinks, sharp bends, and other conditions which would be deleterious to the
finished product. Manufacturing processes shall be done neatly and accurately.
All bends shall be made by controlled means to insure uniformity of size and
shape.
3.10.2 Castings. All castings shall be sound and free from patching,
misplaced coring, warping, or any other defect which reduces the casting's
ability to perform its intended function.
3.10.3 Bolted connections. Boltholes shall be accurately punched or drilled
and shall have the burrs removed. Washers or lockwashers shall be provided in
accordance with good commercial practice, and all bolts, nuts, and screws shall
be tight.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business